Yamaha RX-V4600 MCXSP10 Manual - Page 110
Problem, Cause, Remedy, Refer to, effect speakers - problems
UPC - 027108922683
View all Yamaha RX-V4600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
TROUBLESHOOTING Problem The sound suddenly goes off. Only the speaker on one side can be heard. Only the center speaker outputs substantial sound. No sound from the effect speakers No sound from the center speaker No sound from the surround speakers No sound from the surround back speakers No sound from the subwoofer Cause Remedy Refer to page The protection circuitry has been activated Check that the impedance selector setting is correct. 26 because of a short circuit, etc. Check the speaker wires are not touching each other and then turn this unit back on. - The sleep timer has turned the unit off. Turn on the power, and play the source again. - The sound is muted. Press MUTE to cancel a mute. 35 Incorrect cable connections. Connect the cables properly. If the problem persists, the cables may be defective. 18 Incorrect balance settings in the GUI menu. Adjust the Speaker Level settings. 65 When playing a monaural source with a CINEMA DSP program, the source signal is directed to the center channel, and the front and surround speakers output effect sounds. The sound field programs are turned off. Press STRAIGHT/EFFECT to turn them on. 39 You are using a source or program Try another sound field program. combination that does not output sound 34 from all channels. The output level of the center speaker is set to minimum. Raise the level of the center speaker. 65 Center is set to "None" in Speaker Set. Select the appropriate setting for the center speaker. 62 One of the HiFi DSP programs (except for Try another sound field program. 7ch Stereo) has been selected. 34 The output level of the surround speakers Raise the output level of the surround speakers. is set to minimum. 62 Surround is set to "None" in Speaker Set. Select the appropriate setting for the surround left and right speakers. 62 A monaural or stereo source is being played with STRAIGHT. Press STRAIGHT/EFFECT to turn on the sound fields. - Presence speakers are selected. Select "Surround Back" in PR/SB Select. 61 Surround is set to "None" in Speaker Set. If the surround left and right speakers are set to "None", surround back speakers are automatically set to "None". Select the appropriate setting for the 62 surround left and right speakers. Surround Back is set to "None" in Speaker Set. Select "Small x1", "Small x2", "Large x1" or "Large x2". 63 Bass Out is set to "Front" when a Dolby Digital or DTS signal is being played. Select "SWFR" or "Both". 63 Bass Out is set to "SWFR" or "Front" Select "Both". when a 2-channel source is being played. 63 The source does not contain low bass signals. 106