Yamaha RX-V4600 MCXSP10 Manual - Page 58

SYSTEM OPTIONS Changing parameter settings Use the remote control to access and adjust each parameter. (Speaker set is used in the following example to change parameter settings.) Manual Setup > Basic > Speaker Set > 1 ++ TV VOL CH -- + VOL - AMP SOURCE TV TV MUTE TV INPUT MUTE TOP TITLE BAND PRESET EXIT MENU PRG SELECT PURE DIRECT ENTER NIGHT AUDIO RETURN A/B/C/D/E DISPLAY STRAIGHT EFFECT 1 5 2-4 1 Set AMP/SOURCE/TV to AMP, then press TOP on the remote control. The top display appears. AMP SOURCE TV TOP TITLE 3 Press k / n repeatedly to select the parameter you want to adjust. Presence Bass Out Bass Cross Over SWFR Phase 40Hz 60Hz 80Hz (THX) 90Hz 100Hz 4 Press ENTER or h, then press k / n repeatedly to change the setting of the item you want to adjust. Presence Bass Out Bass Cross Over SWFR Phase 40Hz 60Hz 80Hz (THX) 90Hz 100Hz Stereo/Surround Input Select Manual Setup Auto Setup System Memory Sound Basic Option 2 Press k / n repeatedly to select a menu, then press h to enter the selected menu. Test Tone Speaker Set Speaker Distance Speaker Level Front Center Surround 5 Press EXIT. y If you want to continue adjusting parameter settings, press ENTER to return to the previously selected menu item. Notes • The available parameters may be displayed on more than one page of the GUI display. To scroll through pages, press k / n. • You cannot change parameter values when Memory Guard is set to "On". If you want to change the parameter values, set Memory Guard to "Off" (see page 68). Memory back-up The memory back-up circuit prevents the stored data from being lost even if this unit is set in the standby mode, the power cable is disconnected from the AC outlet, or the power supply is temporarily cut due to power failure. However, if the power is cut for more than one week, the parameter values will return to the factory settings. If this happens, edit the parameter value again. Front Center Surround Surround Back Presence Large Small None 54