Yamaha RX-V4600 MCXSP10 Manual - Page 30

CONNECTIONS Speaker impedance setting Follow the procedure below to change the impedance setting for all speakers. CAUTION If you are using 6 ohm speakers, set the impedance to 6 ohms before using this unit. Be sure this unit is in the standby mode. 1 On the front panel, while holding down STRAIGHT/EFFECT, press STANDBY/ON. "SP IMP.-8ΩMIN" appears on the front panel display. Turning on the power When all connections are complete, turn on the power of this unit. 1 STANDBY /ON INPUT AUDIO MULTI CH SELECT INPUT A/B/C/D/E PRESET/ TUNING PRESET/ TUNING TUNING FM/AM MEMORY MODE SOURCE/ DVD REMOTE MD/TAPE DTV CD-R CBL/SAT TUNER VCR 1 CD DVR/ VCR 2 SPEAKERS A B SILENT CINEMA S VIDEO REC OUT/ZONE 2 OPTIMIZER MIC PHONES EDIT MAN'L/AUTO FM AUTO/MAN'L ZONE ON/OFF ZONE CONTROL MAIN VIDEO ZONE 2 ZONE 3 L AUDIO R OPTICAL VIDEO/AUX TONE STRAIGHT CONTROL EFFECT PROGRAM PURE DIRECT VOLUME STRAIGHT EFFECT STANDBY /ON SP IMP.-8 MIN POWER TV POWER AV STANDBY SYSTEM POWER A B AUDIO SELECT SLEEP PHONO TUNER CD MULTI CH IN V-AUX CBL/SAT MD/TAPE CD-R DTV VCR 1 DVR/VCR2 DVD 1 ++ SELECT AMP + 2 Press STRAIGHT/EFFECT to select the impedance of your speakers. If you are using 6 ohm speakers, select 6 ohms; if you are using 8 ohm speakers, select 8 ohms. 3 Press STANDBY/ON to exit the setting. This unit will be set to the standby mode. Note Speaker impedance setting function is located in the Advanced menu (see page 86). 1 Press STANDBY/ON (or SYSTEM POWER on the remote controls) to turn on the power of this unit. SYSTEM POWER STANDBY /ON or Front panel Remote control 2 Turn on the video monitor connected to this unit. Note Press STANDBY/ON again (or STANDBY on the remote control) to enter the standby mode. 26