Yamaha RX-V4600 MCXSP10 Manual - Page 82

REMOTE CONTROL FEATURES 4 Press the buttons for the functions you want to include in the macro operation in sequence. You can set up to 10 steps (10 functions). After you have set 10 steps, "FULL" appears and the remote control automatically exits the macro mode. Clearing function sets You can clear all changes made in each function set, such as learned functions, macros, renamed source names and setup remote control codes. 1 Set AMP/SOURCE/TV to AMP or SOURCE. POWER TV A POWER STANDBY SYSTEM POWER AV 2 B AUDIO SELECT SLEEP PHONO TUNER 3 CD MULTI CH IN MCR 2: AV POWER MCR 3: AUDIO SELECT V-AUX CBL/SAT MD/TAPE CD-R DTV VCR 1 DVR/VCR2 DVD 1 MCR 1: DVD Indicates the number of macro steps entered Flashes alternately so you can set the next step Note To change the selected source component, press SELECT k / n. Pressing the input selector buttons will program a macro step, whereas SELECT k / n only changes the selected component and corresponding component control area. 5 Press MACRO again when the operation sequence you want to program is complete. Note "ERROR" appears in the display window if you press a button not indicated in the respective step, or if you press more than one button simultaneously. Memory back-up If the remote control is without batteries for more than 2 minutes, or if exhausted batteries remain in the remote control, the contents of the memory may be cleared. If the memory is cleared, insert new batteries, set up the remote control code(s) and program any acquired functions that may have been cleared. AMP SOURCE TV 2 Press CLEAR by using a ballpoint pen or similar object. "CLEAR" appears in the display window. CLEAR Note If you do not complete each of the following steps within 30 seconds, the clearing mode will be automatically canceled. In this case, press CLEAR again. 3 Press k / n to select the clear mode. L;CD (L: name of a component) Clears all learned functions in the respective component control area. Press an input selector button to select the component. L;AMP Clears all learned functions for this unit's control area. L;ALL Clears all learned functions. M;ALL Clears all programmed macros RNAME Clears all renamed source names. FCTRY Clears all remote functions and returns the remote to the factory settings. 4 Press and hold CLEAR again for about 3 seconds. "WAIT" appears in the display window. If clearing was successful, "C;OK" appears in the display window. CLEAR y Once you have cleared a learned function for a button, the button reverts to the factory setting (or to the manufacturer setting, if you have set remote control codes). Note "L;ALL" and "FCTRY" may take about 30 seconds to complete. 78