ZyXEL omni.net Plus User Guide - Page 43

COMMAND +FIE=n +FPS=n +FLO=n +FPR=n +FBO=n +FEA=n +FCR=n +FCQ=, +FRQ=pql,cbl Omni 56K Plus Series User's Guide Table 4-11 Service Class 2.0 Commands DESCRIPTION Procedure Interrupt parameter Page Transfer Status Flow Control Select Serial Port Rate Control Phase C Data Bit Order Phase C Received EOL alignment Capability to Receive Copy Quality disable/enable Receive Quality Thresholds VALUE nsr= 1:Non-standard frames are reported. n=0:Disable n=1:Enable n=1:Received page is good. n=2:Page is bad; retrain is requested. n=3:Page is good; retrain is requested. n=4:Page is bad; procedure interrupt is requested. n=5:Page is good; procedure interrupt is requested. n=0:No flow control n=1:Sets XON/ XOFF software flow control n=2:Sets CTS/RTS hardware flow control n=0:Automatic DTE rate detection by the DCE n>0:Serial rate is fixed at the value multiplied by 2400 bps. n=0:Selects direct bit order n=1:Selects reversed bit order n=0:EOL patterns are as received n=0:Not receive message data or poll a remote device. n=1: Receives message data or poll a remote device. rq= 0:Receive copy quality check is disable. rq=1:Receive copy quality check is enable. tq= 0:Transmit copy quality check is disable. tq=1:Transmit copy quality check is enable. pgl= 0-64h:Specifies the percentage of good lines cbl= 0-ffh:Specifies the maximum tolerable number of consecutive bad lines. Command Sets 4-15