ZyXEL omni.net Plus User Guide - Page 47

Omni 56K Plus Series User's Guide 4.6 S-Register Descriptions In most bit-mapped S-registers, the default bit value is 0. Non-0 default values are followed by an asterisk. In some cases, default values are shown in the reference column preceded by +. Some bits are reserved for factory use and should not be changed. S-Register default values may vary depending on the country. Table 4-15 Basic S-Registers "ATSn=x" COMMAND S0= S1= S2= S3= S4= S5= S6= S7= S8= S9= S10= S11= FUNCTION & DESCRIPTION Sets the number of rings on which the modem will answer. 0 value disables auto-answer. Counts and stores number of rings from an incoming call. Defines escape code character, default '+' (43 dec.). A value of 128-255 disables the escape code. Defines ASCII Carriage Return. Defines ASCII Line Feed. Defines ASCII Backspace. A value of 128-255 disables the Backspace key's delete function. Sets the number of seconds the modem waits before dialing if 'X0' or 'X1' is selected. If a setting of 'X2,' 'X7' is selected, the modem will dial as soon as it detects a dial tone. This register also sets the time-out interval for the "W" dial modifier to wait for the dial tone. (See also S41b4) Sets duration, in number of seconds modem waits for a carrier. Sets duration, in seconds, for pause (,) option in Dial command and pause between command re-executions for Repeat (>) command. Sets duration, in tenths of a second of remote carrier signal before recognition. (Ignored if in non-FSK or half-duplex operation) Sets duration, in tenths of a second, modem waits after loss of carrier before hanging up. Sets duration and spacing, in milliseconds, of dialed Touch-Tones. +REF. +000 +000 +043 +013 +010 +008 +003 +060 +002 +006 +007 +070 Table 4-16 Extended S-Registers "ATSn=x" COMMAND BIT DEC HEX FUNCTION AND DESCRIPTION S13= bit dec hex Bit-mapped register. 1 2 2 Capture modem manufacturer information during V.42 handshake, can be displayed at ATI2 line if available ('Flash' or ' ZyXEL' stands for ZyXEL connection) S14= bit dec hex Bit-mapped register: 1 0 0 Grant Remote Digital Loop-back test request. 2 2 Deny Remote Digital Loop-back test request. (Default) S15= bit dec hex Bit-mapped register. REF. +000 +002 &T4 &T5* +066 Command Sets 4-19