ZyXEL omni.net Plus User Guide - Page 51

Omni 56K Plus Series User's Guide Table 4-16 Extended S-Registers "ATSn=x" COMMAND BIT DEC HEX FUNCTION AND DESCRIPTION REF. 6-4 16- 10-70 Speaker volume control, increments of 32 in decimal L0-7 112 value. S25= 0-255 0-FF Specify the time delay that DTR signal needs to be OFF +000 before it will be recognized, in 10 ms units. If S25=0, the delay time is set to 4 ms. S27= bit dec hex Bit mapped register. +156 0-2 Modem error control. 0 0 No error control. &K0 1 1 MNP4 + MNP3 (see also S41.0) &K1 2 2 MNP4 + MNP5 (see also S38.5, S41.0) &K2 3 3 V.42+MNP4 &K3 4 4 V.42 + V.42bis (compatible with &K2) (Default) &K4* 5 5 V.44 &K5 3-5 0 0 Flow control disabled. &H0 24 18 Hardware (RTS/CTS) flow control. (Default) &H3* 32 20 Software (XON/XOFF) flow control. &H4 40 28 Reserved. &H5 6-7 Signal quality. 0 0 No response to poor signal quality. *Q0 64 40 Retrain action taken if signal quality is poor. *Q1 128 80 Adaptive rate (auto fall-back /forward) when signal quality changes. (Defaults) *Q2* S41.2 192 C0 Disconnect when signal quality is poor. *Q3 S28= bit dec hex Bit mapped register. +068 0 0 0* Single line RJ-11 phone jack (Default) &J0* 1 1 Multiple phone/modem line, RJ12/RJ13 phone jack &J1 1 0 0* Panel key is normal (Default) *L0* 2 2 Panel key is locked *L1 2-3 0 0 Destructive, expedited break. &Y0 1 4 Non-destructive, expedited break. (Default) &Y1* 10 8 Non-destructive, un-expedited break. &Y2 4-5 0 0 No guard tone. (Default) &G0* 16 10 Reserved &G1 32 20 1800 Hz guard tone. &G2 6 0 0 DTE/DCE rate follows link rate. (See also S18, S44b6) &B0 64 40 DTE/DCE rate is fixed at the DTE setting, range from &B1* 300-460.8 Kbps. (Default, also see S18, S44b6) Command Sets 4-23