2013 Chevrolet Cruze Owner Manual - Page 106
2013 Chevrolet Cruze Manual
Page 106 highlights
5-4 Instruments and Controls If the windshield wiper lever is then moved to off before the driver door is opened or within 10 minutes, the wipers will restart and move to the base of the windshield. If the ignition is turned to LOCK/ OFF while the wipers are performing wipes due to windshield washing, the wipers continue to run until they reach the base of the windshield. needing a signal from the GPS satellites. When the compass display shows CAL, drive the vehicle for a short distance in an open area where it can receive a GPS signal. The compass system will automatically determine when the GPS signal is restored and provide a heading again. See Compass Messages on page 5‑27 for more information on the messages that may be displayed for the compass. been activated. See Washer Fluid on page 10‑21 for information on filling the windshield washer fluid reservoir. { WARNING In freezing weather, do not use the washer until the windshield is warmed. Otherwise the washer fluid can form ice on the windshield, blocking your vision. Clear snow and ice from the wiper blades and windshield before using them. If frozen to the windshield, carefully loosen or thaw them. Damaged blades should be replaced. See Wiper Blade Replacement on page 10‑27. Heavy snow or ice can overload the wiper motor. Wipe Parking If the ignition is turned to LOCK/ OFF while the wipers are on LO, HI, or INT, they will immediately stop. Compass The vehicle may have a compass display in the Driver Information Center (DIC). The compass receives its heading and other information from the Global Positioning System (GPS) antenna, StabiliTrak, and vehicle speed information. Avoid covering the GPS antenna, located on the roof, for long periods of time with objects that may interfere with the antenna's ability to receive a satellite signal. The compass system is designed to operate for a certain number of miles or degrees of turn before Clock The infotainment system controls are used to access the time and date settings through the menu system. See Operation on page 7‑4 for information about how to use the menu system. For vehicles with a connective radio or navigation system, see the infotainment manual.