2013 Chevrolet Cruze Owner Manual - Page 233

Driving and Operating in the blind zone. The sensor may be blocked by mud, dirt, snow, ice, or slush. This message may also activate during heavy rain or due to road spray. The vehicle does not need service. For cleaning, see Exterior Care on page 10‑83. SERVICE SIDE DETECTION SYSTEM: If this message appears, the system needs service. Take the vehicle to your dealer. The RVC system can assist the driver when backing up by displaying a view of the area behind the vehicle. 9-43 { WARNING The RVC system does not display children, pedestrians, bicyclists, animals, or any other object located outside the camera's field of view, below the bumper, or under the vehicle. Perceived distances may be different from actual distances. Do not back the vehicle using only the RVC screen, during longer, higher speed backing maneuvers, or where there could be cross traffic. Failure to use proper care before backing may result in injury, death, or vehicle damage. Always check behind and around the vehicle before backing. An image appears on the infotainment screen when the vehicle is shifted into R (Reverse). The infotainment screen goes to the previous screen after approximately 10 seconds once the vehicle is shifted out of R (Reverse). To cancel the delay, do one of the following: . Press a hard key on the infotainment system. Shift into P (Park). Reach a vehicle speed of 8 km/h (5 mph). FCC Information See Radio Frequency Statement on page 13‑15 for information regarding Part 15 of the Federal Communications Commission (FCC) rules and Industry Canada Standards RSS-GEN/210/220/310. . . Turning the Rear Vision Camera System On or Off To turn the RVC system on or off: 1. Shift into P (Park). 2. Press the CONFIG button to enter the configure menu options. 3. Select Display. 4. Select Rear Camera Options. Rear Vision Camera (RVC) This vehicle may have the RVC system. Read this entire section before using it.