2013 Chevrolet Cruze Owner Manual - Page 318
2013 Chevrolet Cruze Manual
Page 318 highlights
10-72 Vehicle Care 5. If this vehicle is the RS model, locate the front or rear jack cover on the rocker molding near the tire being changed. Place your hand behind the edge of the cover on the rocker molding. Pull down and out to remove the cover. The cover will remain attached to the molding by a tether. 6. Place the jack under the vehicle. 7. If you have a coin/pierce jack, attach the jack handle extension to the jack by sliding the hook through the end of the jack. If you have a hex head jack, place the hex tube end of the wrench over the hex head of the jack. 8. Position the jack lift head at the jack location nearest the flat tire. The location is indicated by a notch in the flange. The jack must not be used in any other position. Notice: Make sure that the jack lift head is in the correct position or you may damage your vehicle. The repairs would not be covered by your warranty. 2. Turn the wheel wrench counterclockwise once on each wheel nut to loosen it. Do not remove them yet. 3. Place the jack near the flat tire. 4. Place the wheel blocks on both sides of the tire at the opposite corner of the tire being changed. See If a Tire Goes Flat on page 10‑60 for proper wheel block placement.