2013 Chevrolet Traverse Owner Manual - Page 123
2013 Chevrolet Traverse Manual
Page 123 highlights
Instruments and Controls To calibrate the compass, use the following procedure: Compass Calibration Procedure 1. Before calibrating the compass, make sure the compass zone is set to the variance zone in which the vehicle is located. See "Compass Variance (Zone) Procedure" earlier in this section. Do not operate any switches such as window, sunroof, climate controls, seats, etc. during the calibration procedure. 2. Press the vehicle information button until PRESS V TO CALIBRATE COMPASS displays. 3. Press the set/reset button to start the compass calibration. 4. The DIC will display CALIBRATING: DRIVE IN CIRCLES. Drive the vehicle in tight circles at less than 8 km/h (5 mph) to complete the calibration. The DIC will display CALIBRATION COMPLETE for a few seconds when the calibration is complete. The DIC display will then return to the previous menu... 5-7 \ FWD. Turn f clockwise. Press 5. To decrease the time or date, do one of the following: ... Clock (Radio without Touchscreen) To adjust the time and date: 1. Turn the ignition key to ACC/ ACCESSORY or ON/RUN, then press O to turn the radio on. 2. Press G to display HR, MIN, MM, DD, YYYY (hour, minute, month, day, and year). 3. Press the pushbutton located under any one of the labels to be changed. 4. To increase the time or date, do one of the following: . © SEEK. Press s REV. Turn f counterclockwise. Press To change the time default setting from 12 hour to 24 hour or to change the date default setting from month/day/year to day/month/year: 1. Press G and then the pushbutton located under the forward arrow that displays on the radio screen until the time 12H (hour) and 24H (hour), and the date MM/DD (month and day) and DD/MM (day and month) display. 2. Press the pushbutton located under the desired option. Press the pushbutton below the selected label. Press . ¨ SEEK.