2013 Chevrolet Traverse Owner Manual - Page 365

Vehicle Care For vehicles being dinghy towed, the vehicle should be run at the beginning of each day and at each RV fuel stop for about five minutes. This will ensure proper lubrication of transmission components. Reinstall the fuse to start the vehicle. To tow the vehicle from the front with all four wheels on the ground: 1. Position the vehicle to be towed, shift the transmission to P (Park), and turn the ignition to LOCK/OFF. 2. Secure the vehicle to the towing vehicle. 3. Set the parking brake. 4. Turn the ignition to ACC/ ACCESSORY. 5. Shift the transmission to N (Neutral). 6. To prevent the battery from draining while the vehicle is being towed, remove the 15 amp ECM fuse and the 15 amp Onstar fuse. These are in the battery compartment behind the passenger seat on the floor. Also, remove the 50 amp BATT1 fuse from the underhood fuse block and store all fuses in a safe location. See Engine Compartment Fuse Block on page 10‑29. 7. Release the parking brake. Notice: If the vehicle is towed without performing each of the steps listed under "Dinghy Towing," the automatic transmission could be damaged. Be sure to follow all steps of the dinghy towing procedure prior to and after towing the vehicle. 10-71 Notice: If 105 km/h (65 mph) is exceeded while towing the vehicle, it could be damaged. Never exceed 105 km/h (65 mph) while towing the vehicle. Once the destination is reached: 1. Set the parking brake. 2. Reinstall the fuses. 3. Shift the transmission to P (Park), turn the ignition to LOCK/OFF and remove the key from the ignition. 4. Disconnect the vehicle from the towing vehicle. Notice: Do not tow a vehicle with the front drive wheels on the ground if one of the front tires is a compact spare tire. Towing with two different tire sizes on the front of the vehicle can cause severe damage to the transmission.