2013 Chevrolet Traverse Owner Manual - Page 142
2013 Chevrolet Traverse Manual
Page 142 highlights
5-26 Instruments and Controls information button again until the DIC displays REAR TIRES kPa (PSI) LEFT ## RIGHT ##. If a low tire pressure condition is detected by the system while driving, a message advising you to add air to a specific tire will appear in the display. See Tire Pressure on page 10‑42 and Tire Messages on page 5‑38 for more information. If the tire pressure display shows dashes instead of a value, there may be a problem with your vehicle. If this consistently occurs, see your dealer for service. COMPASS ZONE SETTING This display will be available if the vehicle has a compass. See Compass on page 5‑5 for more information. COMPASS RECALIBRATION This display will be available if the vehicle has a compass. See Compass on page 5‑5 for more information. Blank Display This display shows no information. message as a reminder that the system has been turned off. See Object Detection System Messages on page 5‑36 and Rear Vision Camera (RVC) on page 9‑35. UNITS Press the vehicle information button until UNITS displays. This display allows you to select between metric or English units of measurement. Once in this display, press the set/ reset button to select between METRIC or ENGLISH units. All of the vehicle information will then be displayed in the unit of measurement selected. FRONT TIRES or REAR TIRES On vehicles with the Tire Pressure Monitor System (TPMS), the pressure for each tire can be viewed in the DIC. The tire pressure will be shown in either kilopascals (kPa) or pounds per square inch (psi). Press the vehicle information button until the DIC displays FRONT TIRES kPa (PSI) LEFT ## RIGHT ##. Press the vehicle Trip/Fuel Menu Items 3 (Trip/Fuel): ODOMETER Press this button to scroll through the following menu items: Press the trip/fuel button until ODOMETER displays. This display shows the distance the vehicle has been driven in either kilometers (km) or miles (mi). Pressing the trip odometer reset stem will also display the odometer. To switch between English and metric measurements, see "UNITS" earlier in this section. TRIP A and TRIP B Press the trip/fuel button until TRIP A or TRIP B displays. This display shows the current distance traveled in either kilometers (km) or miles (mi) since the last reset for each trip odometer. Both trip odometers can be used at the same