2013 Chevrolet Traverse Owner Manual - Page 67
2013 Chevrolet Traverse Manual
Page 67 highlights
Seats and Restraints 5. Remove the seat by tilting it slightly upward, and then pulling it out of the rear of the vehicle in one motion. 6. Replace the bolts in the floor holes for storage. 2. Place the seat on the vehicle floor so that the front seat hooks are on the vehicle bars. 3. Reinstall the bolts, and torque to 55 Y (41 lb ft). Pull up on the seat to make sure it is locked in place. 4. Raise the seatback to its upright position. Push and pull on the seatback to make sure it is locked into place. 5. Push the headrest up into position. Push and pull on the headrest to make sure it is locked into place. 6. Reconnect the center safety belt mini-latch to the mini-buckle. Do not let it twist. 3-13 Safety Belts This section of the manual describes how to use safety belts properly. It also describes some things not to do with safety belts. Installing the Third Row Seats To reinstall a third row seat: 1. Before installing the seat the seatback must be folded forward. See "Folding the Seatback" earlier in this section. The seats must be placed in the proper locations to attach correctly. The wider seat must be installed on the driver side and the narrower seat on the passenger side. Remove the bolts from the holes in the floor before installing the seats. { WARNING Do not let anyone ride where a safety belt cannot be worn properly. In a crash, if you or your passenger(s) are not wearing safety belts, injuries can be much worse than if you are wearing safety belts. You can be seriously injured or killed by hitting things inside the vehicle harder or by being ejected from the vehicle. In addition, anyone who is not buckled up can strike other passengers in the vehicle. (Continued)