2013 Chevrolet Traverse Owner Manual - Page 155
2013 Chevrolet Traverse Manual
Page 155 highlights
Instruments and Controls You can receive more than one tire pressure message at a time. To read the other messages that may have been sent at the same time, press the set/reset button or the trip odometer reset stem. The DIC also shows the tire pressure values. See Driver Information Center (DIC) (Without DIC Buttons) on page 5‑28 or Driver Information Center (DIC) (With DIC Buttons) on page 5‑23. comes on and stays on, there may be a problem with the TPMS. See your dealer... 5-39 AWD system overheat Loss of wheel or vehicle speed Certain other vehicle electrical conditions TIRE LEARNING ACTIVE This message displays when the Tire Pressure Monitor System (TPMS) is relearning the tire positions on your vehicle. The tire positions must be relearned after rotating the tires or after replacing a tire or sensor. See Tire Rotation on page 10‑48, Tire Pressure Monitor System on page 10‑44, and Tire Pressure on page 10‑42 for more information. SERVICE TIRE MONITOR SYSTEM On vehicles with the Tire Pressure Monitor System (TPMS), this message displays if a part on the TPMS is not working properly. The tire pressure light also flashes and then remains on during the same ignition cycle. See Tire Pressure Light on page 5‑21. Several conditions may cause this message to appear. See Tire Pressure Monitor Operation on page 10‑45 for more information. If the warning This message turns off when the compact spare tire is replaced by a full-size tire, the differential fluid cools or the above conditions are no longer present and the warning message is reset. To reset the warning message manually, turn the ignition off and then back on again after 30 seconds. If the message stays on, see your dealer. See All-Wheel Drive on page 9‑24. Transmission Messages ALL WHEEL DRIVE OFF If your vehicle has the All-Wheel Drive (AWD) system, this message displays when there is a temporary condition making the AWD system unavailable. The vehicle will run in 2WD. This could be caused by: . SERVICE ALL WHEEL DRIVE This message displays if a problem occurs with the All-Wheel Drive (AWD) system. The vehicle will run in 2WD. This could be caused by: . . An electronics problem Worn out or overheated clutch plates Various electrical issues A compact spare tire on the vehicle .