2014 Chevrolet Corvette Owner Manual - Page 34

2-6 Keys, Doors, and Windows 12. To program additional transmitters, repeat Steps 8-11. Press and hold the ENGINE START/STOP button for 12 seconds if programming is complete. Return the key base back into the RKE transmitter. Programming without a Recognized Transmitter 8. Place the new transmitter in the steering column transmitter pocket with the buttons facing up and the base toward the opening facing the passenger side. 9. Press the ENGINE START/ STOP button. 10. The DIC displays READY FOR REMOTE # 4 or 5, up to 8. 11. Press K on each newly programmed transmitter to complete the process. If there are no currently recognized transmitters available, follow this procedure to program up to eight transmitters. This feature is not available in Canada. This procedure will take approximately 30 minutes to complete. The vehicle must be off and all transmitters to be programmed must be present. 1. The vehicle must be off. 2. Remove the key from the transmitter and insert the vehicle key into the key cylinder above the license plate. 3. Open the hatch/trunk. longer work. Each vehicle can have up to eight transmitters programmed to it. Programming with a Recognized Transmitter A new transmitter can be programmed to the vehicle when there is one recognized transmitter. 1. The vehicle must be off and both the recognized and new transmitters must be with you. 2. Remove key base from recognized RKE transmitter. 3. Place the recognized transmitter in the cupholder. 4. Insert the vehicle key into the key cylinder above the license plate. 5. Open the hatch/trunk. 6. Turn the key five times within ten seconds. 7. The DIC displays READY FOR REMOTE # 3 or 4, up to 8.