2011 Chrysler 300 Owner Manual - Page 163

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 161 Turn Signals Move the multifunction lever up or down and the arrows on each side of the instrument cluster flash to show proper operation of the front and rear turn signal lights. NOTE: • If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb. If an indicator fails to light when the lever is moved, it would suggest that the indicator bulb is defective. Lane Change Assist Tap the lever up or down once, without moving beyond the detent, and the turn signal (right or left) will flash three times then automatically turn off. High/Low Beam Switch Push the multifunction lever away from you to switch the headlights to high beam. Pull the multifunction lever toward you to switch the headlights back to low beam. 3 Flash-To-Pass You can signal another vehicle with your headlights by • A "Turn Signal On" message will appear in the EVIC lightly pulling the multifunction lever toward you. This (if equipped) and a continuous chime will sound if the will turn on the high beams headlights until the lever is vehicle is driven more than 1 mile (1.6 km) with either released. turn signal on. Map/Reading Lights These lights are mounted between the sun visors on the overhead console. Each light is turned on by pressing the lens. Press the lens a second time to turn off the light. These lights also turn on when a door is opened, or when