2013 Chrysler Town & Country Owner Manual - Page 267

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 265 which may not be long enough for HomeLink® to pick up the signal during programming. Similar to this Canadian To reprogram a channel that has been previously trained, law, some U.S. gate operators are designed to time-out in follow these steps: the same manner. 1. Turn the ignition switch to the ON/RUN position. It may be helpful to unplug the device during the cycling 2. Press and hold the desired HomeLink® button until process to prevent possible overheating of the garage the indicator light begins to flash after 20 seconds. Do door or gate motor. not release the button. 1. Cycle the ignition to the ON/RUN position. 3. Without releasing the button proceed with "Programming A Rolling Code" Step 2 and follow all remaining 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink® button you wish to program steps. while keeping the HomeLink® indicator light in view. Canadian/Gate Operator Programming 3. Continue to press and hold the HomeLink® button, For programming transmitters in Canada/United States while you press and release ("cycle"), your hand-held that require the transmitter signals to "time-out" after transmitter every two seconds until HomeLink® has several seconds of transmission. successfully accepted the frequency signal. The indiCanadian radio frequency laws require transmitter signals cator light will flash slowly and then rapidly when to time-out (or quit) after several seconds of transmission - fully trained. Reprogramming A Single HomeLink® Button 3