2013 Chrysler Town & Country Owner Manual - Page 470

468 STARTING AND OPERATING Normal Starting Using The ENGINE START/STOP Button 1. The transmission must be in PARK or NEUTRAL. 2. Press and hold the brake pedal while pressing the ENGINE START/STOP button once. 3. The system takes over and attempts to start the vehicle. If the vehicle fails to start, the starter will disengage automatically after 10 seconds. To Turn Off The Engine Using ENGINE START/STOP Button 1. Place the shift lever in PARK, then press and release the ENGINE START/STOP button. 2. The ignition switch will return to the OFF position. 3. If the shift lever is not in PARK, the ENGINE START/ STOP button must be held for two seconds and vehicle speed must be above 5 mph (8 km/h) before the engine will shut off. The ignition switch position will remain in the ACC position until the shift lever is in 4. If you wish to stop the cranking of the engine prior to PARK and the button is pressed twice to the OFF the engine starting, press the button again. position. If the shift lever is not in PARK and the NOTE: Normal starting of either a cold or a warm engine ENGINE START/STOP button is pressed once, the is obtained without pumping or pressing the accelerator EVIC (if equipped) will display a "Vehicle Not In pedal. Park" message and the engine will remain running. Never leave a vehicle out of the PARK position, or it could roll.