2013 Chrysler Town & Country Owner Manual - Page 320

318 UNDERSTANDING YOUR INSTRUMENT PANEL Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN position. To turn off the message temporarily, press and release the STEP button on the steering wheel. To reset the oil change indicator system (after performing the scheduled maintenance), perform the following steps. Electronic Vehicle Information Center (EVIC) Display - If Equipped The Electronic Vehicle Information Center (EVIC) features a driver-interactive display that is located in the instrument cluster. For further information, refer to "Electronic Vehicle Information Center (EVIC)". 1. Turn the ignition switch to the ON/RUN position (do 7. Anti-Lock Brake (ABS) Light not start the engine). This light monitors the Anti-Lock Brake System 2. Fully depress the accelerator pedal, slowly, three times (ABS). The light will turn on when the ignition within 10 seconds. switch is turned to the ON/RUN position and 3. Turn the ignition switch to the OFF/LOCK position. may stay on for as long as four seconds. NOTE: If the indicator message illuminates when you If the ABS light remains on or turns on while driving, it start the engine, the oil change indicator system did not indicates that the Anti-Lock portion of the brake system is not functioning and that service is required. However, reset. If necessary, repeat these steps. the conventional brake system will continue to operate normally if the BRAKE warning light is not on.