2014 Chrysler 200 Owner Manual - Page 186

184 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) 5. Press and hold the programmed HomeLink® button away from the HomeLink® button you wish to proand observe the indicator light. gram while keeping the HomeLink® indicator light in • If the indicator light stays on constantly, programview. ming is complete and the garage door/device should activate when the HomeLink® button is pressed. 3. Continue to press and hold the HomeLink® button, • To program the two remaining HomeLink® buttons, while you press and release ("cycle"), your hand-held repeat each step for each remaining button. DO NOT transmitter every two seconds until HomeLink® has erase the channels. successfully accepted the frequency signal. The indicator light will flash slowly and then rapidly when If you unplugged the garage door opener/device for fully trained. programming, plug it back in at this time. 4. Watch for the HomeLink® indicator to change flash Reprogramming A Single HomeLink® Button rates. When it changes, it is programmed. It may take up to 30 seconds or longer in rare cases. The garage To reprogram a channel that has been previously trained, door may open and close while you are programming. follow these steps: 1. Cycle the ignition to the ON/RUN position. 2. Press and hold the desired HomeLink® button until the indicator light begins to flash after 20 seconds. Do not release the button.