2014 Chrysler 200 Owner Manual - Page 229

UNDERSTANDING YOUR INSTRUMENT PANEL 227 • Remote start aborted - Hood ajar • Remote start aborted - Trunk ajar • Remote start aborted - Fuel low • Remote start disabled - System fault • Oil Change Required (with a single chime) • Low Tire (with a graphic of the car showing which tire(s) is/are low - with a single chime and ЉInflate to XXЉ). Refer to ЉTire Pressure Monitoring SystemЉ in ЉStarting and OperatingЉ. flash in the EVIC display for approximately five seconds after a single chime has sounded to indicate the next scheduled oil change interval. The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style. Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN position. To turn off the message temporarily, press and release the MENU button. To reset the oil change indicator system (after performing the scheduled maintenance), perform the following procedure: 4 • Check TPM System (with a single chime) Refer to ЉTire Pressure Monitoring SystemЉ in ЉStarting and Operat- 1. Turn the ignition switch to the ON position (do not start the engine.) ingЉ. Oil Change Required - If Equipped Your vehicle is equipped with an engine oil change indicator system. The Oil Change Required message will 3. Turn the ignition switch to the LOCK position. 2. Fully depress the accelerator pedal slowly three times within 10 seconds.