2014 Chrysler 200 Owner Manual - Page 408

406 WHAT TO DO IN EMERGENCIES 3. Align the valve notch in the wheel cover with the 6. Finish tightening the lug nuts. Push down on the valve stem on the wheel. Install the cover by hand, wrench while at the end of the handle for increased snapping the cover over the two lug nuts. Do not use leverage. Tighten the lug nuts in a star pattern until a hammer or excessive force to install the cover. each nut has been tightened twice. For the correct lug nut torque refer to Torque Specifications in this sec4. Install the remaining lug nuts with the cone shaped tion. If in doubt about the correct tightness, have them end of the nut toward the wheel. Lightly tighten the checked with a torque wrench by your authorized lug nuts. dealer or service station. WARNING! To avoid the risk of forcing the vehicle off the jack, do not tighten the wheel nuts fully until the vehicle has been lowered. Failure to follow this warning may result in personal injury. 7. After 25 miles (40 km) check the lug nut torque with a torque wrench to ensure that all lug nuts are properly seated against the wheel. Vehicles Without Wheel Covers 1. Mount the road tire on the axle. 5. Lower the vehicle to the ground by turning the jack 2. Install the remaining lug nuts with the cone shaped handle counterclockwise. end of the nut toward the wheel. Lightly tighten the lug nuts.