2014 Chrysler 300 Owner Manual - Page 276

274 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink® button you wish to program To reprogram a channel that has been previously trained, while keeping the HomeLink® indicator light in view. follow these steps: Reprogramming A Single HomeLink® Button 3. Simultaneously press and hold both the Homelink® button you want to program and the hand-held trans2. Press and hold the desired HomeLink® button until mitter button. the indicator light begins to flash after 20 seconds. Do 4. Continue to hold both buttons and observe the indinot release the button. cator light. The Homelink® indicator will flash slowly 3. Without releasing the button proceed with "Programand then rapidly after HomeLink® has received the ming A Rolling Code" step 2 and follow all remaining frequency signal from the hand-held transmitter. Release both buttons after the indicator light changes steps. from slow to rapid. Programming A Non-Rolling Code For programming Garage Door Openers manufactured 5. Press and hold the programmed HomeLink® button and observe the indicator light. before 1995. • If the indicator light stays on constantly, program1. Turn the ignition switch to the ON/RUN position. ming is complete and the garage door/device should activate when the HomeLink® button is pressed. 1. Cycle the ignition to the ON/RUN position.