2014 Chrysler 300 Owner Manual - Page 380

378 STARTING AND OPERATING 3. The system takes over and attempts to start the 3. If the shift lever/shift selector is not in PARK, the ENGINE START/STOP button must be held for two vehicle. If the vehicle fails to start, the starter will seconds or three short presses in a row with the disengage automatically after 10 seconds. vehicle speed above 5 mph (8 km/h) before the engine 4. If you wish to stop the cranking of the engine prior to will shut off. The ignition switch position will remain the engine starting, press the button again. in the ACC position until the shift lever/shift selector is in PARK and the button is pressed twice to the OFF NOTE: Normal starting of either a cold or a warm engine position. If the shift lever/shift selector is not in PARK is obtained without pumping or pressing the accelerator and the ENGINE START/STOP button is pressed pedal. once, the EVIC (if equipped) will display a "Vehicle To Turn Off The Engine Using ENGINE Not In Park" message and the engine will remain START/STOP Button running. Never leave a vehicle out of the PARK 1. Place the shift lever/shift selector in PARK, then press position, or it could roll. and release the ENGINE START/STOP button. NOTE: If the ignition switch is left in the ACC or RUN (engine not running) position and the transmission is in 2. The ignition switch will return to the OFF position. PARK, the system will automatically time out after 30 minutes of inactivity and the ignition will switch to the OFF position.