2012 Dodge Challenger Owner Manual SRT8 - Page 352

350 WHAT TO DO IN EMERGENCIES Select Knob (5) is in the Sealant Mode position and not the Pressure Gauge (3) can read as high as 70 psi (5 Bar). Air Mode. Press the Power Button (4) to turn On the The Pressure Gauge (3) will decrease quickly from apTIREFIT kit. proximately 70 psi (5 Bar) to the actual tire pressure when the Sealant Bottle (1) is empty. 2. Connect the Power Plug (8) to a different 12 Volt power outlet in your vehicle or another vehicle, if avail- 2. The pump will start to inject air into the tire immediable. Make sure the engine is running before turning ON ately after the Sealant Bottle (1) is empty. Continue to the TIREFIT kit. operate the pump and inflate the tire to the pressure indicated on the tire pressure label on the driver-side 3. The Sealant Bottle (1) may be empty due to previous latch pillar (recommended pressure). Check the tire presuse. Call for assistance. sure by looking at the Pressure Gauge (3). NOTE: If the Mode Select Knob (5) is on Air Mode and If the tire does not inflate to at least 26 psi (1.8 Bar) the pump is operating, air will dispense from the Air pressure within 15 minutes: Pump Hose (7) only, not the Sealant Hose (6). • The tire is too badly damaged. Do not attempt to drive If the sealant (white fluid) does flow through the the vehicle further. Call for assistance. Sealant Hose (6): NOTE: If the tire becomes over-inflated, press the 1. Continue to operate the pump until sealant is no Deflation Button to reduce the tire pressure to the recomlonger flowing through hose (typically takes 30 - 70 secmended inflation pressure before continuing. onds). As the sealant flows through the Sealant Hose (6),