2012 Dodge Challenger Owner Manual SRT8 - Page 355

WHAT TO DO IN EMERGENCIES 353 4. Have the tire inspected and repaired or replaced at the 4. Clean any remaining sealant from the TIREFIT housing. earliest opportunity at an authorized dealer or tire ser5. Position the new Sealant Bottle (1) in the housing so vice center. that the Sealant Hose (6) aligns with the hose slot in the 5. Replace the Sealant Bottle (1) and Sealant Hose (6) front of the housing. Press the bottle into the housing. An assembly at your authorized dealer as soon as possible. audible click will be heard indicating the bottle is locked into place. Refer to "(F) Sealant Bottle and Hose Replacement." NOTE: When having the tire serviced, advise the au- 6. Verify that the cap is installed on the fitting at the end thorized dealer or service center that the tire has been of the Sealant Hose (6) and return the hose to its storage area (located on the bottom of the air pump). sealed using the TIREFIT service kit. (F) Sealant Bottle And Hose Replacement: 1. Uncoil the Sealant Hose (6) (clear in color). 7. Return the TIREFIT kit to its storage location in the vehicle. 6 2. Locate the round Sealant Bottle release button in the JUMP-STARTING PROCEDURES If your vehicle has a discharged battery it can be jumprecessed area under the sealant bottle. started using a set of jumper cables and a battery in 3. Press the Sealant Bottle release button. The Sealant another vehicle or by using a portable battery booster Bottle (1) will pop up. Remove the bottle and dispose of pack. Jump-starting can be dangerous if done improperly it accordingly. so please follow the procedures in this section carefully.