2001 Nissan Quest Owner's Manual - Page 200

BREAK-IN SCHEDULE ● If you depress the brake pedal while pushing the RES/ACCEL switch, the RES/ ACCEL function is cancelled. In order for the RES/ACCEL switch to operate, the COAST/SET must be used to re-engage the system. ● The cruise control automatically cancels if the vehicle slows down more than 5 MPH (8 km/h) below the set speed. ● Move the selector lever to N (Neutral). The SET light goes out. To reset at a faster cruising speed, use one of the following three methods: a) Depress the accelerator pedal. When the vehicle attains the desired speed, push and release the COAST/SET switch. b) Push and hold the RES/ACCEL switch. When the vehicle attains the speed you desire, release the switch. c) Push and release the RES/ACCEL switch. Each time you do this, the set speed increases by about 1 MPH (1.6 km/h). To reset at a slower cruising speed, use one of the following three methods. Starting and driving 5-11 a) Tap the brake pedal. When the vehicle attains the desired speed, push the COAST/SET switch and release it. b) Push and hold the COAST/SET switch. Release the switch when the vehicle slows down to the desired speed. c) Push and release the COAST/SET switch. Each time you do this, the set speed decreases by about 1 MPH (1.6 km/h). To resume the preset speed, push and release the RES/ACCEL switch. The vehicle resumes the last set cruising speed when the vehicle speed is over 29 MPH (47 km/h). During the first 1,000 miles (1,600 km), follow these recommendations for the future reliability and fuel economy of your new vehicle. ● Avoid driving for long periods at constant speed, either fast or slow. ● Do not accelerate at full throttle in any gear. ● Avoid quick starts. ● Avoid hard braking as much as possible. ● Do not tow a trailer for the first 500 miles (800 km).