2001 Nissan Quest Owner's Manual - Page 75
2001 Nissan Quest Manual
Page 75 highlights
CHILD RESTRAINT WITH TOP TETHER STRAP The LATCH system anchors are located at the rear of the seat cushion near the seatback. A label is attached to the seatback to help you locate the LATCH system anchors. Some child restraints may also require the use of a top tether strap. See ''Top Tether Strap Child Restraint'' later in this section for installation instructions. When installing a child restraint, carefully read and follow the instructions in this manual and those supplied with the child restraint. When you install a LATCH system compatible child restraint with lower anchor attachments in the rear seat, follow these steps: WARNING! Inspect the lower anchors by inserting your fingers into the lower anchor area and feeling to make sure there are no obstructions over the LATCH system anchors, such as seat belt webbing or seat cushion material. The child restraint will not be secured properly if the LATCH system anchors are obstructed. 1. To install the LATCH system compatible child restraint, insert the child restraint LATCH system anchor attachments into the anchor points on the rear seat. If the child restraint is equipped with a top tether, see ''Top Tether Strap Child Restraint'' later in this section for installation instructions. 2. After attaching the child restraint and before placing the child in it, use force to tilt the child restraint from side to side and tug it forward to make sure that the child restraint is securely held in place. 3. Check to make sure that the child restraint is properly secured prior to each use. A child restraint anchored with a top tether strap can be installed on the second row bench seat, a second row bucket seat, or the three-passenger bench seat in the second or third row. The chart indicates where the tether strap must be attached and the section of this manual that contains the instructions for tethering. 1-68 Seats, restraints and supplemental air bag systems