2005 Nissan Murano Owner's Manual - Page 136
2005 Nissan Murano Manual
Page 136 highlights
¼ To install the mechanical key to the intelligent key, securely lock the lock knob and then check that the mechanical key will not move. Windows open/close with the mechanical key See "Opening and closing windows" on the previous page. FCC Notice: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules (the certification number). These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause haumful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna - Increase the separation between the Pre-driving checks and adjustments CAUTION Be sure to carry the Intelligent Key with the mechanical key installed in it. Locking/unlocking the doors with the key (mechanical key and valet key) SPA1951 OPERATION WITH THE MECHANICAL KEY AND VALET KEY If the Intelligent Key cannot be used because its battery is discharged, use the metal key to lock or unlock the doors and use the mechanical key or the valet key, which is registered to the NISSAN Vehicle Immobilizer System components, to start the engine. The doors can be locked/unlocked by inserting the mechanical and valet key into the key cylinder in the driver's door in the same way as the ordinary key. Starting the engine with the mechanical key and valet key 1. Securely depress the brake pedal. 2. Insert the mechanical key or the valet key into the ignition switch. 3. Turn the ignition switch to the START position and start the engine. 4. After starting the engine, release the switch. For important safety information, see the "5. Starting and driving" section. Removing the mechanical key ¼ Release the lock knob at the back of the intelligent key and remove the mechanical key. 3-23