2005 Nissan Murano Owner's Manual - Page 147

section and "Pedal position adjustment" and "Outside mirrors" earlier in this section. 3. Turn the ignition ON. 4. Push the SET switch and, within 5 seconds, push the memory switch (1 or 2) fully for at least 1 second. The indicator light for the pushed memory switch will come on and stay on for approximately 5 seconds after pushing the switch. After the indicator light goes off, the selected positions are stored in the selected memory (1 or 2). If memory is stored in the same memory switch, the previous memory will be deleted. With the key removed from the ignition switch, push the unlock button on the keyfob. The driver's seat, pedals (Brake and Accelerator) and outside mirrors will move to the memorized position. work or will stop operating under the following conditions: ¼ when the vehicle speed is above 4 MPH (7 km/h). ¼ when any two or more of the memory switches and the SET switch is simultaneously pushed while the automatic drive positioner is operating. ¼ when the adjusting switch for the driver's seat, pedals and outside mirror are operated while the automatic drive positioner is operating. ¼ when the memory switch (1 or 2) and the SET switch is not pushed for at least 1 second. ¼ when the seat has been already moved to the memorized position. ¼ when no seat position is stored in the memory switch. ¼ when the engine is started while moving the automatic drive positioner. ¼ when the shift selector lever is moved from the P position to any other position (However, it will not be cancelled if the switch is pushed while the seat is returning to the previous positions (entry/exit function).). Confirming memory storage ¼ Turn the ignition switch to the ON position and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 seconds. When the memory has stored the position, the indicator light will stay on for approximately 5 seconds. Selecting the memorized position 1. Set the sift selector lever to the P (Park) position. 2. Turn the ignition ON. 3. Push the memory switch (1 or 2) fully for at least 1 second. The driver's seat, pedals (Brake and Accelerator) and outside mirrors will move to the memorized position with the indicator light flashing, and then the light will stay on for approximately 5 seconds. Linking a remote keyless entry to a stored memory position A remote keyless entry can be linked to a stored memory position with the following procedure. 1. Follow the steps for storing a memory position. 2. While the indicator light for the memory switch being set is illuminated for 5 seconds, push the unlock button on the remote keyless entry. The indicator light will blink. After the indicator light goes off, the remote keyless entry is linked to that memory setting. SYSTEM OPERATION The automatic drive positioner system will not 3-34 Pre-driving checks and adjustments