2005 Nissan Murano Owner's Manual - Page 154

("ENGINE OIL" or "TIRE ROTATION") when the vehicle is driven the set distance, turn ON the service alert key. To turn the service alert key ON, refer to "How to use the setting button" in this section. When the vehicle is driven the set distance, the MAINTENANCE screen will be automatically displayed and the Maintenance menu ("ENGINE OIL", "TIRE ROTATION" and "TIRE PRESSURE" (if so equipped)) will blink. To return to the previous display after the Maintenance Notice message is displayed, push the PREV button. The "MAINTENANCE NOTICE" screen displays each time the key is turned ON until one of the following conditions are met: ¼ "MAINT" button or "TRIP RESET" button is pushed. ¼ "Service alert key" is set OFF. ¼ the maintenance interval is set again. SAA0646 SAA0798 HOW TO USE "MAINT" (Maintenance) BUTTON Pushing the "MAINT" button will change the maintenance menu as follows: ENGINE OIL → TIRE ROTATION → TIRE PRESSURE (if so equipped) To reset the driving distance, push the "MAINT" button or "TRIP RESET" button for more than approximately 1.5 seconds. Move the joystick to left or right to set the distance. To automatically display the Maintenance menu Tire pressure information (if so equipped) Pressure indication in ** psi on the screen indicates that the pressure is being measured. After a few driving trips, the pressure for each tire will be displayed randomly. The order of tire pressure figures displayed on the screen does not correspond with the actual order of the tire position. Tire pressure rises and falls depending on the heat caused by the vehicle's traveling condition and the temperature. In case of low tire pressure, a message (FLAT Display screen, heater, air conditioner and audio systems 4-5