2011 Suzuki Grand Vitara Owner's Manual - Page 233
2011 Suzuki Grand Vitara Manual
Page 233 highlights
OTHER CONTROLS AND EQUIPMENT HomeLink® (if equipped) any garage door opener model manufactured before April 1, 1982). A garage door that cannot detect an object - signaling the door to stop and reverse - does not meet current U.S. federal safety standards. For more information, contact HomeLink® at www.homelink.com or by calling 1-800355-3515. 66J092 HomeLink® button. Begin with "Programming HomeLink®" - step 2). HomeLink® and the HomeLink® house are registered trademarks of Johnson Controls, Inc. The HomeLink® Wireless Control System provides a convenient way to replace up to three hand-held radio-frequency (RF) transmitters used to activate devices such as gate operators, garage door openers, entry door locks, security systems, even home lighting. Additional HomeLink® information can be found on the Internet at www.homelink.com or by calling 1-800355-3515. Before programming HomeLink® to a garage door opener or gate operator, make sure that people and objects are out of the way of the device to prevent potential harm or damage. When programming a garage door opener, it is advised to park outside of the garage. Do not use HomeLink® with any garage door opener that lacks safety stop and reverse features as required by U.S. federal safety standards (this includes Retain the original transmitter of the RF device you are programming for use in other vehicles as well as for future HomeLink® programming. It is also suggested that upon the sale of the vehicle, the programmed HomeLink® buttons be erased for security purposes. Refer to "Programming HomeLink®" (step 1) only) or, for assistance, contact HomeLink® at www.homelink.com or by calling 1-800355-3515. 66J050 Programming HomeLink® NOTE: Some vehicles may require the ignition switch to be turned to the second (or "accessories") position or the "on" position for programming and/or operation of HomeLink®. It is also recommended that a new battery be placed in the hand-held transmitter of the device being programmed to HomeLink® for quicker training and accurate transmission of the radiofrequency signal. Do not repeat "Programming HomeLink®" - step 1) to train additional devices to a second or third 1) Press and hold the two outer HomeLink® buttons (buttons one and three) - releasing only when the indicator light begins to flash (after 20 seconds). Do not hold the buttons for longer than 30 seconds and do not repeat step 1) to program a second and/or third hand-held transmitter to the remaining two HomeLink® buttons. 2) Position the end of your hand-held transmitter 5-14 cm (1-3 inches) away from the HomeLink® button you wish to program while keeping the indicator light in view. 3) Simultaneously press and hold both the chosen HomeLink® and hand-held transmitter buttons. Do not release the buttons until step 4) has been completed. 5-80 79K21-03E