2011 Suzuki Grand Vitara Owner's Manual - Page 261
2011 Suzuki Grand Vitara Manual
Page 261 highlights
Engine Oil and Filter: 1, 2 INSPECTION AND MAINTENANCE Replace the Oil Filter 2.4 L engine NOTE: • When it is difficult to remove the oil filter, we recommend you take your vehicle to your SUZUKI dealer for oil filter replacement. • For 3.2 L engine, since special procedures are required, we recommend you take your vehicle to your SUZUKI dealer for oil filter replacement. EXAMPLE Refill with Oil and Check for Leaks 1) Pour oil through the filler hole and install the filler cap. For the approximate capacity of the oil, refer to the "Capacities" item in the "SPECIFICATIONS" section. 2) Start the engine and look carefully for leaks at the oil filter and drain plug. Run the engine at various speeds for at least 5 minutes. 3) Stop the engine and wait about 5 minutes. Check the oil level again and add oil if necessary. Check for leaks again. 54G093 78K055 (1) Oil filter (2) 3/4 turn 5) Tighten the filter 3/4 turn from the point of contact with the mounting surface (or to the specified torque) using an oil filter wrench. 6) Reinstall the engine under cover. Tightening torque specification 14 Nm (10.1 lb-ft, 1.4 kg-m) 1) Using an oil filter wrench, turn the oil filter counterclockwise and remove it. 2) Using a clean rag, wipe off the mounting surface on the engine where the new filter will be seated. 3) Smear a little engine oil around the rubber gasket of the new oil filter. 4) Screw on the new filter by hand until the filter gasket contacts the mounting surface. CAUTION When replacing the oil filter, it is recommended that you use a genuine SUZUKI replacement filter. If you use an after-market filter, make sure it is of equivalent quality and carefully follow the manufacturer's instructions and precautions. CAUTION To tighten the oil filter properly, it is important to accurately identify the position at which the filter gasket first contacts the mounting surface. CAUTION To prevent oil leakage, make sure that the oil filter is tight, but do not overtighten it. 7-12 79K21-03E