2011 Suzuki Grand Vitara Owner's Manual - Page 27
2011 Suzuki Grand Vitara Manual
Page 27 highlights
Door Locks: 3, 5, 8 BEFORE DRIVING Programming/erasing the remote controller code yourself Your new vehicle was originally equipped with two remote controllers. If you have lost one of the remote controllers, you should change the remote controller code in your vehicle's memory as soon as possible for security. If you purchase additional remote controllers, the new remote controllers need to be programmed into your vehicle's memory. You can perform this yourself by using the following procedure: NOTE: • You can program up to four remote controller codes into your vehicle's memory. The four codes may be the same or different. • If you try to program a fifth code, the four remote controller codes that are programmed will be cleared automatically. • If you program a new remote controller code, all of the old remote controller codes that are in your vehicle's memory will be erased automatically. When you program a new remote controller, you should reprogram any additional remote controllers at the same time. • To purchase new remote controllers, see your SUZUKI dealer. • Before you begin programming, have all of your remote controllers available. To program a new remote controller 1) Close all the doors of the vehicle. 2) Sit in the driver's seat and confirm that the driver's door is unlocked. 3) Insert the key into the ignition switch. 4) Complete steps 1 through 6 described below within 25 seconds after step 3). 7. Proceed to step 5) within 60 seconds after the engine has started. NOTE: You cannot program the remote controller if you don't complete steps 1 through 6 within 25 seconds. You cannot program the remote controller if you do not proceed to step 5) within 60 seconds after the engine has started. 5) Turn the ignition switch to the "LOCK" position. A buzzer will sound twice and the door lock switch will be activated from the lock position to the unlock position automatically. 6) Press the "LOCK", "UNLOCK" or "PANIC" button on the remote controller. A buzzer will sound twice and the door lock switch will be activated from the lock position to the unlock position automatically. If you want to program an additional remote controller, repeat the procedure of step 6) using the additional remote controller. NOTE: Complete step 6) within 30 seconds. You can program up to four remote controllers. UNLOCK (2) LOCK (1) 79K005 1. Push the power door locking switch of the driver's door to the lock position and then push it to the unlock position. 2. Repeat step 1 two more times. 3. Push the power door locking switch of the driver's door to the lock position. 4. Remove the key from the ignition switch and then insert it again. 5. Repeat step 4 three more times. 6. To start the engine, turn the ignition switch to the "START" position. Wait for 3 seconds. 2-10 79K21-03E