2011 Suzuki Grand Vitara Owner's Manual - Page 302

Jump Starting Instructions: 7 EMERGENCY SERVICE WARNING • Use the jack only to change wheels on level, hard ground. • Never jack up the vehicle on an inclined surface. • Never raise the vehicle with the jack in a location other than the designated jacking point near the wheel to be changed. • Make sure that the jack is raised at least 51 mm (2 inches) before it contacts the flange. Use of the jack when it is within 51 mm (2 inches) of being fully collapsed may result in failure of the jack. • Never get under the vehicle when it is supported by the jack. • Never run the engine when the vehicle is supported by the jack and never allow passengers to remain in the vehicle. Changing Wheels To change a wheel, use the following procedure: To remove the spare wheel: 1) Remove the jack and tools from the vehicle. (A) (1) 78K151 (2) 3) Unhook the under claws (1) and the middle claws (2) one by one. (3) 78K150 2) Release the lock at the underneath of the spare wheel full cover (A) as shown in the illustration. 78K152 4) Unhook the upper claws (3), and remove the wheel full cover. 8-3 79K21-03E