2011 Suzuki Grand Vitara Owner's Manual - Page 303
2011 Suzuki Grand Vitara Manual
Page 303 highlights
Jump Starting Instructions: 7 Towing a Disabled Vehicle: 6 If the Starter Does Not Operate: 2, 9 EMERGENCY SERVICE NOTE: Remove the full wheel cover from the bottom part to the upper part. Otherwise, the claws may be broken. (Half cover type) facing the wheel. Tighten each nut snugly by hand until the wheel is securely seated on the hub. (B) 78K153 (4) (5) 78K060 NOTE: If your vehicle is equipped with the half cover, remove the center bolt (4), then remove the outer cover (5) of the spare wheel half cover. 5) Pull out the lock cover (B) fitted on the lock nut of the spare wheel while inserting the key full into the key hole of the lock cover (B). 6) Remove the lock nut and wheel nuts of the spare wheel, then remove the spare wheel with both hands. To change the wheel: 1) Loosen, but do not remove the wheel nuts. 2) Jack up the vehicle (follow the jacking instructions in this section) 3) Remove the wheel nuts and wheel. 4) Before installing the new wheel, clean any mud or dirt off from the surface of the wheel and hub with a clean cloth. Clean the hub carefully; it may be hot from driving. 5) Install the new wheel and replace the wheel nuts with their cone shaped end EXAMPLE 81A057 Tightening torque for wheel nut 100 Nm (10.0 kg-m, 72.3 lb-ft) 6) Lower the jack and fully tighten the nuts in a crisscross fashion with a wrench as shown in the illustration. 8-4 79K21-03E