3Com 3CRWE554G72 User Guide - Page 83
Troubleshooting, Basic Connection Checks, Browsing to the Gateway Configuration Screens
UPC - 662705468846
View all 3Com 3CRWE554G72 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
6 TROUBLESHOOTING Basic Connection Checks ■ Check that the Gateway is connected to your computers and to the cable/DSL modem, and that all the equipment is powered on. Check that the LAN Status and Cable/DSL Status LEDs on the Gateway are illuminated, and that any corresponding LEDs on the cable/DSL modem and the NIC are also illuminated. ■ Ensure that the computers have completed their start-up procedure and are ready for use. Some network interfaces may not be correctly initialized until the start-up procedure has completed. ■ If the link status LED does not illuminate for a port that is connected, check that you do not have a faulty cable. Try a different cable. Browsing to the Gateway Configuration Screens If you have connected your Gateway and computers together but cannot browse to the Gateway configuration screens, check the following: ■ Confirm that the physical connection between your computer and the Gateway is OK, and that the LAN Status LEDs on the Gateway and NIC are illuminated and indicating the same speed (10Mbps or 100Mbps). Some NICs do not have status LEDs, in which case a diagnostic program may be available that can give you this information. ■ Ensure that you have configured your computer as described in Chapter 3, Setting Up Your Computers. Restart your computer while it is connected to the Gateway to ensure that your computer receives an IP address. ■ When entering the address of the Gateway into your web browser, ensure that you use the full URL including the http:// prefix (e.g. http://192.168.1.1). ■ Ensure that you do not have a Web proxy enabled on your computer. Go to the Control Panel and click on Internet Options. Select the