Acer Altos 1100e Acer Altos 1100e User's Guide - Page 157

IDE secondary channel master, 3-6 IDE secondary channel slave, 3-6 Initialize SCSI before IDE, 3-19 Installing 32 bit PCI cards, 2-22 Installing a DIMM, 2-20 Installing a Pentium III processor, 2- 15 Installing an AGP card, 2-23 Installing an expansion board, 1-24 Installing and removing a heatsink, 2-13 Installing expansion cards, 2-22 32 bit PCI cards, installing, 2-22 AGP card, installing, 2-23 Installing drives, 1-7 3.5-inch drive, 1-7 5.25-inch drives, 1-9 Installing hot-swap cages, 1-11 BP-L3, installing, 1-11 BP-L3 hard disk drive tray, installing and removing, 1-15 BP-L5, installing, 1-16 BP-L5 hard disk drive tray, installing and removing, 1-19 Comparison table, BP-L3 and BP- L5, 1-11 Installing components 2-10 ESD precautions, 2-11 Instructions, post-installation, 2-12 Instructions, pre-installation, 2-11 Installing the RDM module, 2-25 Installing the termination board, 2-18 Internal cache, 3-5, 3-33 Internal structure, 1-4 J Jumper and connector locations, 2-5 Jumper settings, 2-6 Jumpers and connectors, 1-26, 2-5 Connector functions, 2-7 Jumper settings, 2-6 Locations, 2-5 L Leaving setup, 3-49 Left panel, 1-6 Load setup default settings, 3-48 M Main board ID, 3-9 Main board s/n, 3-9 Major components, 2-3 Memory configurations, 2-19 Memory parity mode, 3-7 Memory test, 3-19 Memory upgrade, 2-19 Configurations, 2-19 DIMM, installing, 2-20 DIMM, removing, 2-21 Reconfiguring the system, 2-21 Memory/cache configuration, 3-33 N Num lock after boot, 3-19 O Onboard devices configuration, 3-22 Onboard USB, 3-7, 3-28 Opening the housing panels, 1-5 Front panel, 1-2, 1-5 Index 3