Adaptec 5325302053 User Guide - Page 163
Removing iSCSI Targets and Adding the Appliance IP Address, Logging into the iSCSI Targets
UPC - 753253020539
View all Adaptec 5325302053 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 163 highlights
4 Continue adding user names and passwords until all users are included on the list. Note The user list must have at least one name on it. 5 Click Cancel to close the window. 6 Repeat Step 2 to 5 for each logical device with CHAP authentication. 7 Click Next, then click Next again. 8 Click Apply, then click Yes. Removing iSCSI Targets and Adding the Appliance IP Address 1 On the iSCSI Storage Host, go to the Start menu and open Microsoft iSCSI Initiator. The iSCSI Initiator Properties window opens. 2 Click the Targets tab, then log off any iSCSI target whose status is 'Reconnecting'. 3 Click the Persistent Targets tab, then remove any iSCSI target whose status is 'Inactive'. 4 Click the Discovery tab. 5 From the list of IP addresses, remove any address that does not belong to the iSCSI Storage Appliance. 6 Click Add. 7 Enter the IP address for the iSCSI data port on your iSCSI Storage Appliance (as set in "Step 2: Configuring the iSCSI Storage Appliance" on page 36), then click OK. If your iSCSI Storage Appliance has two iSCSI data ports, repeat this step for the other port. Logging into the iSCSI Targets 1 In the iSCSI Initiator Properties program, click the Targets tab. 2 Select an iSCSI target, then click Log On.... 3 Select Automatically restore this connection.... If CHAP is enabled on this iSCSI target, click Advanced, select CHAP logon information, enter the user name and password ('target secret') for that iSCSI target, then click OK. Note The target secret is the password you set in "Removing iSCSI Targets and Adding the Appliance IP Address" on page 157. 4 Click OK to log on to the iSCSI target.