Adaptec 5325302053 User Guide - Page 181

# Either the 'iqn' or 'eui' format. An example of these settings would be: # TargetName=iqn.1992-08.com.adaptec:c9c631.20070806040135.l1 5 Modify the authentication settings, • one-way CHAP-uncomment OutgoingUsername & OutgoingPassword and enter the same values given when creating a logical device from ASM/CLI. • Mutual CHAP-uncomment OutgoingUsername, OutgoingPassword, IncomingUsername & IncomingPassword. For incoming username/password we need define those at the target using • logical CHAP user • logical CHAP password. This password should be different from while creating logical from ASM/CLI. Note For Mutual CHAP- we cannot use same password for both Outgoing and Incoming. AUTHENTICATION SETTINGS To globally configure a CHAP username and password for initiator # authentication by the target(s), uncomment the following lines: # OutgoingUsername=user1 OutgoingPassword=adaptecadaptec # # To globally configure a CHAP username and password for target(s) # authentication by the initiator, uncomment the following lines: # IncomingUsername=user1 IncomingPassword=adaptecadaptec 6 Exit all the iSCSI sessions and restart the iSCSI services. /etc/init.d/iscsi restart 7 Verify if the new iSCSI device is added. fdisk -l 8 Perform all relevant linux commands to partition, format, mount, run stress, and unmount.