Apple IMAC Service Source - Page 109
Replacing the 17\, housing, check that the display is properly seated in the rear housing.
UPC - 067540444435
View all Apple IMAC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
Replacing the 17"Display Panel 1. After connecting the display cables, position the display into the rear housing. Place the display into the rear housing, sliding it into position, pushing it in the direction of the arrows. Note: The display mates with tabs/slots in the rear housing. If the display doesn't fit properly and you can't install the three screws along the bottom of the housing, check that the display is properly seated in the rear housing. 2. Holding onto the display, turn it over and lay the display face down on a soft cloth. Push the rear housing in the direction of the arrows. This will mate the housing and display tabs. 100 - iMac (USB 2.0) Take Apart Display, 17" Flat Panel
100 -
iMac (USB 2.0)
Take Apart
Display, 17" Flat Panel
Replacing the 17"Display Panel
1.
After connecting the display cables, position the display into the rear housing. Place
the display into the rear housing, sliding it into position, pushing it in the direction of
the arrows.
Note:
The display mates with tabs/slots in the rear housing. If the display
doesn’t fit properly and you can’t install the three screws along the bottom of the
housing, check that the display is properly seated in the rear housing.
2.
Holding onto the display, turn it over and lay the display face down on a soft cloth.
Push the rear housing in the direction of the arrows. This will mate the housing and
display tabs.