Apple IMAC Service Source - Page 90
Place the copper tape over the wires making sure the wires lay flat. Press the copper
UPC - 067540444435
View all Apple IMAC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
3. Place the copper tape over the wires making sure the wires lay flat. Press the copper tape securely against the Faraday cage. 4. Reassemble the computer and return the system to the customer. Warning: Whenever the bottom housing is opened for service, you must do two things: 1.You must clean the original thermal film from all thermal interface mating surfaces, and reapply thermal paste to the mating surfaces on the thermal pipe. 2. You must tighten the four torx screws on the bottom housing to a minimum of 17 in.-lbs. Use a torque driver (service tool 076-0899) to ensure that the thermal pipe is firmly mated with the top base. If you do not have a torque driver, you must make sure the screws are tightened by hand FIRMLY, BUT NOT FORCIBLY. Failure to follow these steps could cause the computer to overheat and damage internal components. Refer to the topic "Thermal Paste Application" for detailed information. Antenna, Wireless iMac (USB 2.0) Take Apart - 81