Asus AP3000 Hardware Reference - Page 35

Power Supply Mounting

Get Asus AP3000 PDF manuals and user guides View all Asus AP3000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 35 highlights

IV. Hardware Setup • 4-14. SCSI Termination Terminating the SCSI bus "chain" is necessary for SCSI devices to work properly. Ultra2 devices do not have termination jumpers and must be terminated using a terminator on the SCSI cable which means you cannot connect a device on the last connector. Female Terminator for SCSI cable • 4-15. Power Supply Male Terminator for SCSI Board IV. Hardware Setup SCSI/Power Power Supply Mounting Mounting and unmounting the power supply must be done from the inside. Four screws are used to secure the power supply to the chassis back side. AP 3000 Hardware Reference Guide 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
35
IV. Hardware Setup
IV. Hardware Setup
AP 3000 Hardware Reference Guide
• 4-14. SCSI Termination
Female Terminator for SCSI cable
Male Terminator for SCSI Board
• 4-15. Power Supply
Power Supply Mounting
Mounting and unmounting the power supply must be done from the
inside. Four screws are used to secure the power supply to the chassis
back side.
SCSI/Power
Terminating the SCSI bus “chain” is necessary for SCSI devices to work
properly. Ultra2 devices do not have termination jumpers and must be ter-
minated using a terminator on the SCSI cable which means you cannot
connect a device on the last connector.