Asus V2-PE3 V2-PE3 English Edition User's Manual - Page 55
Connectors
View all Asus V2-PE3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
4.4 Connectors 1. Floppy disk drive connector (34-1 pin FLOPPY) This connector is for the provided floppy disk drive (FDD) signal cable. Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive. Pin 5 on the connector is removed to prevent incorrect cable connection when using a FDD cable with a covered Pin 5. FLOPPY ® Floppy Disk Drive Connector NOTE: Orient the red markings on the floppy ribbon cable to PIN 1. PIN 1 2. Serial ATA connectors (7-pin SATA1, SATA2) These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives. SATA2 GND RSATA_RXN1 RSATA_RXP1 GND RSATA_TXN1 RSATA_TXP1 GND SATA1 ® GND RSATA_RXN2 RSATA_RXP2 GND RSATA_TXN2 RSATA_TXP2 GND SATA Connectors Important notes on Serial ATA: • You must install Windows® 2000 Service Pack 4 or the Windows® XP Service Pack1 before using Serial ATA hard disk drives. • When using the connectors in Standard IDE mode, connect the primary (boot) hard disk drive to the SATA1 or SATA2 connector. ASUS Vintage V2-PE3 4-5