Bosch HDI8054U Instructions for Use - Page 40
Warming Drawer Maintenance
![]() |
View all Bosch HDI8054U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
To replace the oven door: 1. Holding the door firmly in both hands, place hinges in hinge slots. 2. Catch the small slot at the base of the hinge (A) in the bottom of the hinge slot (B) in the oven body. Then tilt the door inward and slide the hinges into place. The door should catch at this point and remain firmly attached to the oven body. 3. Open the door all the way to expose the hinges and slots. 4. Push both hinge levers down and away from you until flush with the face of the oven body. 5. Close and open door slowly to be sure it is correctly and securely in place. Door must be straight, not crooked. Warming Drawer Maintenance Removing the Drawer 9 CAUTION To prevent burns, do not remove drawer while hot. Be sure drawer is empty before removing. MED LOW HIGH PROOF _+ Low Med ON/OFF High Proof _+ On/Off B 1. Pull drawer to fully open position. 2. Press down right drawer clip. 3. Lift up left drawer clip. 4. Firmly pull the drawer straight out. Retract cabinet rails while drawer is removed. Replacing the Drawer 1. Be sure cabinet rails are pushed inside cabinet. 2. Align the drawer rails with the cabinet rails. 3. Firmly push the drawer straight into the cabinet until drawer clicks into place. 4. Open and close drawer to test operation. Note: if the drawer will not close, verify that the rail clips are properly positioned. English 37
![](/manual_guide/products/bosch-hdip054u-instructions-use-fad32e3/40.png)