Bosch SHV68E13UC Installation Instructions - Page 6

Avoid Scalding or Electrical Shock Hazard7 / Make sure the water supply and electrical supply ar_ shut off before installation or service, j After locating the proper place for your new dishwasher, you will need to make any required openings to allow for passage of the water, drain and electrical line. In order to avoid interference with the dishwasher when sliding it into the cabinet, place your openings within the dimensions shown in Figure 3 below. NOTE: This dishwasher is designed to be enclosed on the top and both sides by standard residential kitchen cabinetry. Select a location as close to the sink as possible for easy access to water supply and drain lines. For proper dishwasher operation and appearance, ensure that the enclosure is square and has the dimensions shown in Figure 1 below. J J// I I\ Required Openings: 41/4"x 2" (108 x 52mm) - To pass the included electrical E supply junction box through to an adjacent cabinet 4" x 2" (100 x 50mm) - To pass the included water supply line toward the water supply 11/4"(32mm) diameter - To pass the dishwasher drain hose toward the drain con nection If the dishwasher is to be installed in a corner, make sure that there is adequate clearance to open the door. See Figure 2 below. NOTE: If the incoming electric supply, water supply and drain connections are all in the same cabinet, the one 4V4"x 2" (108 x 52mm) hole will be large enough for all three to pass through. Checkclearance[ between / dishwasherdoor / and wall l Countertop Before sliding the dishwasher into the cabinet, remove the hose clip at the back of the dishwasher as shown below and discard. Avoid Electrical Shock/Fire Hazard Do not allow the electrical and water supply lines to touch. 6 E i i...........