Bowflex Xtreme 2 Assembly Manual - Page 10
Step 8, Attach the Cable Shroud to the Pulley Arms, Step 9, Attach the Seat Pad to the Seat Backbone - reviews
View all Bowflex Xtreme 2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Step 8: Attach the Cable Shroud to the Pulley Arms Locate the following items: • Item #23 - Cable Shroud • From Step 7 - Main Assembly • Item #A - (4) 4.2mm X 12mm Self Drilling Screws • Item #L - (4) M4 Washers Line up the bolt holes in the Cable Shroud (Item #23) with the bolt holes in the Right and Left Pulley Arms (Items #12 & 13) on the Main Assembly, as shown in Figure 8. Place (4) M4 Washers (Item #L) over the ends of (4) 4.2mm X 12mm Self Drilling Screws (Item #A), and use these screws to attach the Cable Shroud to the Pulley Arms through the aligned bolt holes. STOP! At this time, review and tighten all hardware installed in Steps 1-8. Figure 8 23 12 13 A L Step 9: Attach the Seat Pad to the Seat Backbone Locate the following items: Figure 9 • Item #16 - Seat Pad • Item #17 - Seat Backbone D 17 • Item #D - (4) 5/16" X 3/4" Hex Head Bolts • Item #N - (4) 5/16" Washers N Turn the Seat Pad (Item #16) cushion side down (holes upward), and place the Seat Backbone (Item #17) over the Seat Pad, lining up the holes, as shown in Figure 9. Place (4) 5/16" Washers (Item #N) over the ends of (4) 5/16" X 3/4" Hex Head Bolts (Item #D) - one washer per bolt. 16 Tightly affix the Seat Backbone to the Seat Pad as shown in Figure 9. Tighten all hardware from Step 9 only at this time.