Bowflex Xtreme 2 Assembly Manual - Page 11

 Step 10: Attach the Seat Pad to the Seat Support Rail Locate the following items: Figure 10 • From Step 9 - Seat Backbone w/ Seat Assembly • From Step 8 - Main Assembly With the Seat Pad (Item #16) cushion side up, align the top two hooks on the Seat Backbone with the lowest pair of "pins" on the Seat Support Rail (Item #7). Tip the seat up while engaging the hooks, and then rotate down for use. 7 16 Take care to only hook the Seat onto the lowest pins until the Seat Back Pad is attached. Note: Reverse this procedure to remove the Seat. Step 11: Attach the Seat Back Pad to the Seat Support Rail Locate the following items: • Item #24 - Seat Back Pad • From Step 10 - Main Assembly • Item #E - (2) 5/16" X 2 1/2" Hex Head Bolts • Item #N - (2) 5/16" Washers Figure 11 24 The Seat Back Pad (Item #24) has two pair of holes on its back. Before attaching the Seat Back Pad to the Seat Support Rail (Item #7), assess which holes to use for your height. The Seat Back Pad should support your middle and upper back when you are seated. Align the bolt holes selected for your height on the Seat Back Pad with the two bolt holes on the Seat Support Rail. Place (2) 5/16" Washers (Item #N) over (2) 5/16" X 2 1/2" Hex Head Bolts (Item #E), and screw the bolts through the aligned bolt holes, securing the Seat Back Pad tightly to the Seat Backbone, as shown in Figure 11. Tighten hardware from Step 11 only at this time. N 7 E