Bowflex Xtreme 2 Assembly Manual - Page 9

Step 6: Attach the Pulley Arms Locate the following items: • Items #12 and #13 - Right and Left Pulley Arms • From Step 5 - Main Assembly • Item #F - (4) 3/8" X 3/4" Hex Head Bolts • Item #O - (4) 3/8" Washers Place the Right Pulley Arm (Item #12) onto the bracket on the Right Frame Rail (Item #2), as shown in Figure 6. Note: Make sure that the bolt holes in the Pulley Arms are facing away from the Rod Pack. Place (2) 3/8" Washers (Item #O) over (2) 3/8" X 3/4" Hex Head Bolts (Item #F) - one washer per bolt. Thread the bolts through the bolt holes in the Frame Rail bracket and the Right Pulley arm, loosely securing the arm in place, as shown in Figure 6. Repeat this process for the Left Pulley Arm (Item #13). Do not tighten hardware from Step 6 at this time. Step 7: Secure Pulley Arms and Attach Chest Pulleys Locate the following items: • Item #14 - (2) Chest Pulleys • From Step 6 - Main Assembly • Item #C - (2) 1/4" X 1/2" Socket Head Cap Bolts • Item #K - (2) 1/2" X 9 1/2" Threaded Studs (Labeled Bolts) • Item #P - (4) 1/2" Washers • Item #S - (4) 1/2" Nylock Nuts Line up the holes in the Right Pulley Arm (Item #12) and the Left Pulley Arm (Item #13) with the holes on the Lower Lat Tower (Item #1), as shown in Figure 7. Slide the (2) 1/2" X 9 1/2" Threaded Studs (Item #K) all the way through the both Pulley Arms and the Lower Lat Tower, and secure tightly, using (4) 1/2" Washers (Item #P) and (4) 1/2" Nylock Nuts (Item #S) over both ends of each Threaded Stud. Slide one Chest Pulley (Item #14) over the Right Pulley Arm, and the other Chest Pulley over the Left Arm. Each Pulley can rest in any of the four holes in the Pulley Arms. Place (1) 1/4" X 1/2" Socket Head Cap Bolt (Item #C) through the hole on the underside of each Pulley Arm - this prevents the Slider Pulleys from sliding off. Do not tighten hardware from Step 7 at this time. Figure 6 O F 12 2 Figure 7 13 14 C K  F 12 14 S P